Dentek Platinum Dental Guard

More Views

Dentek Platinum Dental Guard

Availability: In stock

The DenTek Platinum Dental Guard combines the ease of a ready to wear dental guard with the customization of a formed guard. Protect against damaged caused by nighttime teeth grinding with this customized guard for ultimate comfort.

  • Band adjusts two ways to customize the length and angle while comfort strips adjust for a custom fit.

  • Ready to use right out of the box, no boiling water, heating, or molding required.

  • 2 way adjustable band and cushioned bite pads.

  • Contoured bumpers for comfort 6 month protection guarantee Includes antimicrobial storage case

  • 6 month protection guarantee

  • Includes antimicrobial storage case



Directions Getting Started

• Multiple dental guards SHOULD NOT be worn at the same time.

• Read and follow the dental guard fitting instructions.

• If you need assistance, visit or call 1-800-433-6835 between 8pm and 5pm E.S.T. and one of our trained specialists will help you.

• It may take time for you to adjust to wearing the dental guard, so begin wearing it one hour before you go to sleep.

Fitting Your Dental Guard

• Rinse the dental guard in warm water.

• Begin by test fitting your dental guard. The dental guard is currently in the smallest position. Place on your lower or upper teeth and bite down, making sure to cover at least one molar but not extending past your last molar. *Use a mirror to determine that the bite pad reaches at least one molar.

• If the dental guard doesn't cover at least one molar, follow the instructions for adjustment.

Adjust the Band Length

• To adjust the dental guard band length, slide the molar pad front to back. You will feel a “stop” when you have reached the different adjustment positions. Repeat on the other molar pad so that both the right and left pads are aligned Adjust the Band Height

• To adjust the dental guard band height, tilt the band up and down to the most comfortable position. The band will position itself into one of three available positions.

• Test fit the dental guard again to determine if at least one molar is covered and that it does NOT extend past your last molar on each side. If the dental guard still does not cover at least one molar, try the next notch back on both sides. There are five (5) adjustment positions to achieve the perfect fit.

• There is a built in stop that will now allow the molar pads to move past the first adjustment position or the last adjustment position. Once you have found the correct adjustment position, your dental guard is ready to wear. NOTE: DO NOT force the molar pads further forward on the band. DO NOT bend or flex the front band too much as it may show wear marks or become deformed.